A wide range of data sources
MXS 1.2 Strada, the evolution of MXS Strada, is a 5" color display with great visual impact, configurable to show lap times and all the info coming from the Engine Control Unit, analog/digital inputs, pre-defined math channels and - optionally - the GPS08 Module.
MXS 1.2 Strada is available in two versions:
With the CAN Output you can send messages directly to an existing CAN network in order to improve the range of vehicle control possibilities.
Watch your data in pre-configured pages
MXS 1.2 Strada shows, together with RPM scale, all the data you need, like speed, water temperature and oil pressure, laptimes and much more...
You can choose the custom pages you wish among a wide library of page styles, defining which data to be shown, their end of scale and measure units.
Swapping between pages is quite easy using the pushbuttons.
High contrast TFT display
MXS 1.2 Strada features a high contrast TFT display: its visual quality is always optimal as its ambient light sensor keeps the backlight at the best brightness levels.
The dash is of course available also in the "Street Icons" version (fuel, oil, water temp., etc.).
The ten multicolored RGB shift lights can be customized as you like, defining the RPM threshold for each single gear.
The same flexibility applies to the configurable RGB alarm LEDs: you can configure them in order to turn them on/off depending on analog or digital inputs, ECU values, expansion values, math channels or - optionally - GPS information.
You choose conditions and colors: select a solid alarm or flashing one - and the flashing frequency.
It is also possible to configure an accompanying text message, and set the alarm priorities.
MXS 1.2 Strada features a LOW SIDE type (switch to ground) digital output configurable in order to be activated/deactivated depending on the value of the analog/digital inputs or on impulses coming from the ECU.
This permits to automatically run external systems, i.e. to switch on/off additional lights, to activate/de-activate a cooling fan or circulation pumps, etc. when a certain event happens.
Camera inputs, also for mirror camera
Two analog camera inputs are available, to swap your display into a mirror camera, through pushbutton command or event management.
A modular system
Using the built-in CAN bus you can add expansion modules to visualize additional info:
Thanks to GPS08 Module and Race Studio 3 software, you can immediately get laptimes and all data needed for engine tuning as well as for improving driving technique.
It permits to add 4 0-5Volt analog channels.
It adds 4 K thermocouples.
Wide band Lambda controller LCU-One, with Bosch LSU 4.9 probe, providing all Air/Fuel data and lambda value, allows to perfectly tune the carburetion.
SmartyCam HD cameras
The on-board cameras that overlays on videos the data sampled by your logger.
These are only some of the items that can be added to our MXS 1.2 Strada for incrementing the performance and the data acquired:
Race Studio 3 configuration
MXS 1.2 Strada is to be configured via Race Studio 3: you can create, modify, delete, import and export configurations with all channels, ECU drivers, Math channels, Display Pages, Digital output, Alarms, Shift Lights and all the expansions you need.
|AiM LearnFast E-training Series
|Check out how to use Race Studio 3 Configuration: Part 1 - Part 2